Telegram Account Authentication in Deskgram 2

This guide explains how to log Telegram accounts into Deskgram 2 and prepare them for later workflows. Authentication is the first infrastructure step before warmup, parsing, messaging, invites, comments, or any other module.

What this module does

The module helps you add Telegram accounts to Deskgram 2, choose the login method, configure device parameters, connect proxies if needed, and prepare the accounts for work.

Authentication should not be rushed. If accounts enter the system with wrong proxy or device settings, every next module becomes harder to diagnose.

What to prepare before launch

Prepare:

• phone numbers or account sessions;
• access to confirmation codes;
• a decision between phone login and QR login;
• proxies if the accounts should be assigned from the beginning;
• a device profile strategy;
• a small test batch.

Step 1. Choose the authentication method

Start by choosing how accounts will log in.

Common options:

• phone-based login;
• QR login;
• session-based workflow if your setup supports it.

Choose one main approach for a batch. Mixing several methods without a reason makes the process harder to control.

Step 2. Review basic login parameters

After choosing the method, check the basic input fields and additional login options. Keep the setup focused. Do not enable settings that are not needed for the current account segment.

For large batches, start with a few accounts first and confirm the flow.

Step 3. Configure the device profile

The device profile affects how accounts appear inside the system. If accounts will later be used for long-running workflows, configure device logic before launching many logins.

Step 4. Connect proxies

If your infrastructure uses proxies, connect them during authentication instead of adding them later.

Check:

• which proxy is assigned to which account;
• whether the proxy works before the account goes into warmup;
• whether the same proxy is overloaded;
• whether errors repeat on one route.

What to check after login

After adding accounts, check:

• account status;
• login errors;
• proxy assignment;
• whether the account appears in the account panel;
• whether it is ready for warmup;
• whether it should be separated into a special group.

Do not send newly authenticated accounts directly into active messaging or invite tasks. Move them through preparation first.

Common mistakes

• Logging in a large batch before testing the process.
• Adding accounts without proxy strategy.
• Ignoring device settings.
• Mixing unstable accounts with ready accounts.
• Moving accounts straight into active modules.

Summary

Account authentication is the entry point into Deskgram 2. Treat it as infrastructure, not as a formality.

Log in small batches, check device and proxy settings, review account status, and only then move accounts into warmup or other modules.